Measurement of the electrical potential gradient in the atmosphere by radiosonde

Authors

  • S.P. VENKITESHWARAN
  • B.K. GUPTA
  • B.B. HUDDAR

DOI:

https://doi.org/10.54302/mausam.v5i3.4874

Keywords:

electrical potential gradient, radiosonde

Abstract

In a recent paper Venkiteshwaran, Dhar and Huddar (1953) have described a method to measure the electrical potential gradient in the atmosphere by radiosondes. They have adapted the valve electrometer of Koenigsfeld and Piraux (1951.) with the audio frequency modulated type of radio­sonde used in the U.S.A. The HL 23 valve which works as an electrometer is coupled to the modulator circuit of the American radio­sonde transmitter by disconnecting its tem­perature and humidity elements and replac­ing them with a wire wound resistance of about 350 ohms. This resistance formed the load between the grid and the cathode of the valve electrometer. A small potential of 6 volts is applied between the grid and the cathode of the HL23. The terminals from the collectors at known distances are connect­ed to the plate and the cathode of this valve. The variations in the atmospheric potential gradient cause a corresponding change in the voltage across the load resistance which in turn alters the audio frequency of the modulator circuit of the radiosonde which is recorded on the ground equipment.

Downloads

Published

01-07-1954

How to Cite

[1]
S. . VENKITESHWARAN, B. . GUPTA, and B. . HUDDAR, “Measurement of the electrical potential gradient in the atmosphere by radiosonde”, MAUSAM, vol. 5, no. 3, pp. 253–256, Jul. 1954.

Issue

Section

Shorter Contribution

Most read articles by the same author(s)

1 2 > >>